Maintenance Electric Stacker need to pay attention where

We usually use electric stacker, when, to regular inspection, maintenance and repair, so that not only can prolong the service life of electric stacker, better make it work more power when Fat Face! Example, transmission parts should be there is enough oil on the wearing parts must always check, repair or replacement of mechanical bolts, especially a vibrating parts, such as slewing, lifting arm connecting bolts should be checked for loose, even if you must tighten the loose or replacement.
Here we specifically introduced, electric stacker repairs Note:
1 installation, removal and adjustment rotary mechanism, should be taken to ensure slewing gear reducer centerline parallel to the centerline, and its mating surface is not less than 70%, meshing clearance to fit.
(2) Electric Stacker brakes should be checked frequently and adjust brake shoes and brake wheel clearance, to ensure flexible and reliable. The friction surface, there should be no dirt there, in case of dirt must be washed off with gasoline or thinner.
3 electrics tacker motor has overheated to stop in time, troubleshooting and then continue to run the motor bearing lubrication must be good.
4 Always check Electric Stacker ministries connections, if loose should be tightened. Body connecting bolts should be checked in the body is under pressure tightness of all connections must have a little shaft cotter pin, and the need to open fully.
5 gearbox, gearbox, external gear teeth and other parts of lubricating and hydraulic oil lubricated according to the requirements of the table.
6 Electric Stacker always check all the wires, cables for damage. The dressing should be promptly and replacement to damaged parts.
7 ministries should pay attention to check whether the broken wire rope and pine stock phenomenon. If more than relevant provisions must be immediately replaced.
8 Electric Stacker respective limit switch safety device must be reliable opening and closing of the contacts, the contacts should be polished crater. 8 parts of the brush, the contact surfaces should be kept clean, adjust the brush pressure, so that the contact area of ​​not less than 50%.