Electric Stacker is the battery power as an energy source, a motor as a power source storage device. The main structures include: batteries, motors, hydraulic pumps, cylinders, piston rods, forks, chains, controller, etc. devices. Its main function is to enhance the weight to the desired height.
2013年8月19日星期一
this habit is to make the burnt clutch
In use should avoid prolonged stepping clutch. Some drivers in the frequent shifting when the sake of simplicity and reduction actions, not taxiing off the file, and for a long time stepping on the clutch, this habit is to make the burnt clutch, clutch damage, drive axle gear damage.
Starting essentials
1. Use starter starting time can not electrics tacker 15 seconds, the second time starting with the first interval between the start of not less than two minutes: When the engine begins to work, you should immediately release the switch button to return the starter gear stopped in situ work to prevent damage to the starter by the anti-band:
(2) the amount of hydraulic oil: liquid level in the oil level should be up and down tick in midfield.
3 Check the piping, fittings, pumps, valves for leaks and damage.
4 Check the brake.
(1). Brake pedal air travel should be 20-30 mm;
(2). Before the gap between the base plate and the pedal should be greater than 20 mm;
5 Always check the parking brake, hand position in the end should be in the 15% of the full stop on the ramp.
6 Check the instrumentation, lighting, switches and electrical lines are working correctly.
Battery
1 The role of the battery
Electricity is supplied to the starter, start the engine; generators at low engine speeds is low, the supply of lighting, sound equipment, ignition system power; when the engine at high speed generator power is sufficient, storing excess energy.
(2) the use and maintenance of batteries
1) Keep clean, remove dust and dirt and oxide timely.
2) The battery cable from the battery then column securely installed (note: not available positive and negative polarity).
3). Battery electrolyte should be higher than the plate 10/u15 mm, low, should be added.
4) regular checks of electrolyte specific gravity, the general should be maintained at between 1.22-1.26.
5) Avoid strenuous discharge, such as the use of starter time not too long and so on.
订阅:
博文评论 (Atom)
没有评论:
发表评论